POWER JackPlate: VANCE JPL4400 4” NARROW

VANCE JPL4400 4″ POWER NARROW manual jackplate:

• Powerful and strong, original one-piece JackPlate, with 3-3 secure bolts on both sides, and centralized lifting screw for the engine height, and for the biggest performance
• Recommended product for engines with hydraulic steering solution!
• „BEST BUY” product for mounting bolted motors on BIA standard hole pattern, even interchangeably regardless of any outboard engine brand
• Factory pre-drilled standard BIA hole pattern (327mm on the top, 237mm on the bottom, 203mm vertical spacing)
• MADE IN USA: Made of high strength polished 10mm thick Aircraft Quality Aluminium Alloy
• NARROW JackPlate: 4 inch setback, meaning 10,16cm transom-engine ofset, longitudinal JackPlate size
  Suggestion:      Bigger the engine requires bigger setback!
• 1,5 inch, meaning 3,81cm basic height difference between transom, and engine side, but holes avaiable on the engine side on the same height level
• Possibility to raise the engine height for 4 inches, 10.16 cm in parallel, through the centralized lifting screw
• Alltogether 5,50inch, so 13,97cm possible outboard engine height lifting
• Basic RAW aluminium surface, but optionally hard black, or clear anodizing surface for saltwater or brack water usage protecting the hardware against natural corrosion
• Optional Performance Plate: alumínium coverage on the bottom of the JackPlate, increasing the performance by closing the water upweeling between the structure and give a small flying and lifting surface to holeshot
• Powerful, sturdy narrow jackplate with only 11,34Kg weight, ideal for secure mounting of the upper-mid ranged outboard engines

Brochure

Optional possibilities:

The VANCE JPL4400 POWER JACKPLATE NARROW JackPlate ready to use, immediatelly capable to use product, but could be upgraded with the following optional elements:

Performance Plate:

Aluminium coverage on the bottom, for better performance, close water upwelling when starting, and avoid garbage to block into the jackplate during staying (wash on Rivers)

individually ordered (CODE: PP)

Colour and surface: Basic RAW surface on the basic product!

• Hard Black anodizing for the premium look, or corrosion resistance for saltwater usage individually ordered (CODE: HBA)
• Clear Water anodizing surface for corrosion resistance for saltwater usage individually ordered      (Code: CA)

Transom strengtening solution for inside the boat:

• Transom Plate upper, Optional, always on warehouse (CODE: TP210)
• Transom Plate lower, Optional, always on warehouse (CODE: TP211)

Upper Transom plate recommended til 100HP, and both above 150HP

JackPlate Clamper Plate, for smaller clampered, hanging engines:     

2,54cm thick, white StarBoard with B.I.A hole pattern Optionally ordered (CODE: SB701W)

Bolt kit:

Screws, washers and nuts for installation: (Complete package)

• Transom side 4 pieces (d12mm,100mm, A2 Grade)
• Engine side 4 pieces (d12mm, 50mm A2 Grade)

Optional, allways on stock! (CODE BKBIA)

Silicon:

For insulation, waterproof installation of the jackplate

• SIKAFLEX white Optional, allways on stock! (CODE: SKFLX)