MAX POWER JackPlate: VANCE JPL5500 6” BASIC

VANCE JPL5500 6″ BASIC MAXPOWER manual jackplate:

• Compact size, but the most powerful MAX POWER genuine manual JackPlate for V6-V8 outboard motors, from 225 HP to 400 HP, and weighing up to 350 kg!
• The Most Powerful and strong, original one-piece JackPlate, with 3-3 secure bolts on both sides, and centralized lifting screw for the engine height, and for the biggest performance
• Quality product for mounting bolted motors on BIA standard hole pattern, even interchangeably regardless of any outboard engine brand
• Factory pre-drilled standard BIA hole pattern (327mm on the top, 237mm on the bottom, 203mm vertical spacing)
• It is mandatory to use the internal transom plates: Transom Plate (TP210-TP211) for secure mount
• MADE IN USA: Made of high strength polished 12mm thick Aircraft Quality Aluminium Alloy for the maximum security and strenght!
• Common JackPlate: 6 inch setback, meaning 15,24cm transom-engine ofset, common longitudinal JackPlate size
• 1,5 inch, meaning 3,81cm basic height difference between transom, and engine side, but holes avaiable on the engine side on the same height level
• Possibility to raise the engine height for 4 inches, 10.16 cm in parallel, through the centralized lifting screw
• Alltogether 5,50inch, so 13,97cm possible outboard engine height lifting
• Basic RAW aluminium surface, but optionally hard black, or clear anodizing surface for saltwater or brack water usage protecting the hardware against natural corrosion
• Optional Performance Plate: alumínium coverage on the bottom of the JackPlate, increasing the performance by closing the water upweeling between the structure and give a small flying and lifting surface to holeshot
• The Most Powerful, sturdy common JackPlate with 15,88Kg overall weight, ideal for secure mounting of the biggest V6-V8 outboard engines!

Brochure

Optional possibilities:

The VANCE JPL5500 MAX POWER JackPlate BASIC ready to use, immediatelly capable to use product, but could be upgraded with the following optional elements:

Performance Plate:

Aluminium coverage on the bottom, for better performance, close water upwelling when starting, and avoid garbage to block into the jackplate during staying (wash on Rivers)

individually ordered (CODE: PP)

Colour and surface: Basic RAW surface on the basic product!

• Hard Black anodizing for the premium look, or corrosion resistance for saltwater usage individually ordered (CODE: HBA)
• Clear Water anodizing surface for corrosion resistance for saltwater usage individually ordered      (Code: CA)

Transom strengtening solution for inside the boat:

• Transom Plate upper, MANDATORY!, always on warehouse (CODE: TP210)
• Transom Plate lower, MANDATORY!, always on warehouse (CODE: TP211)

Bolt kit: Screws, washers and nuts for installation: (Complete package)

• Transom side 4 pieces (d12mm,100mm, A2 Grade)
• Engine side 4 pieces (d12mm, 50mm A2 Grade)

Optional, allways on stock! (CODE BKBIA)

Silicon: For insulation, waterproof installation of the jackplate

SIKAFLEX white Optional, allways on stock! (CODE: SKFLX)